Why the same equipment, the same nozzle, some users of the UV printer nozzle can be used for a long time, and some users of the nozzle is always replaced frequently?
The most important reason is related to the user’s daily protection and maintenance of the nozzle. If you want the UV printing nozzle to have a long service life, it has been in the best working state. These daily protection and maintenance work can not be less.
10 maintenance suggestions
1. Shut down in accordance with the prescribed procedures: first close the control software and then turn off the general power switch to ensure the normal return of the car, ensure that the nozzle and ink stack are fully close, and avoid blocking the nozzle.
2. When replacing the ink stack core, it is recommended to use the original ink stack core. Otherwise, there may be phenomena such as nozzle blockage, broken ink, incomplete extraction of ink, and incomplete extraction of residual ink. If the equipment is idle for more than three days, please clean the ink stack core and waste ink pipe with cleaning liquid to prevent drying and blocking.
3.It is recommended that you use the original factory original ink, it is strictly prohibited to use two different brands of ink mixed, in order to avoid chemical reaction, block the nozzle, affect the quality of the picture.
4. Do not plug and remove the USB printing cable with power on to avoid damage to the motherboard.
5.The machine for high-speed printer, please be sure to connect to the ground: ① When the air is dry, the electrostatic problem can not be ignored. (2) When using some inferior materials with strong static electricity, static electricity may cause damage to the safety of the electronic components of the machine and the nozzle. Static electricity will also cause the phenomenon of flying ink when printing. It is forbidden to operate the nozzle with electricity.
6.Because this equipment is a precision printing equipment, it is recommended to equip the power of about 2000W brand voltage regulator.
7.The environment temperature is kept at 15℃-30℃, humidity 35%-65%, keep the working environment clean, avoid dust.
8. Scraper: Clean the ink stack scraper regularly to prevent ink solidification from causing damage to the nozzle.
9.The working platform: keep the table without dust, ink, debris, to prevent scratching nozzle.
10. Ink cartridge: Close the lid immediately after ink injection to prevent dust from entering.