UV printer has no plate making, namely namely the characteristics of dry, not only can print effect, also can print 3D and relief effect, and print materials widely: packing box, acrylic, KT board, u disk, such as glass, ceramic tile, wood, metal, occupy the market quickly after launch, UV printer has become a trend.UV printer in the use of the process is very strict, once the improper operation will damage the life of the equipment, the following dangerous operation.
1.Brute force adjustment nozzle
The use of external force is not standard to adjust the nozzle position.Do not use brute force to replace or fine-tune the sprinkler head. Please treat the sprinkler head with care according to the specification.
2. Ignore the work ground
UV flatbed printer printing is greatly affected by static electricity, should often check the ground equipment connection, regularly sprinkle a little salt water around the ground.
3. Switch circuit at will
Install and remove the UV flatbed printer circuit without turning off the power supply and cutting off the main power supply.This kind of behavior will damage the service life of each system and harm the sprinkler head.
4. The power supply is not turned off after cleaning
Do not protect circuit boards and other internal systems when cleaning.Please turn off the power when cleaning, and be careful not to let water touch the circuit board and other internal systems.
5. Use inferior cleaning fluid
Clean the nozzle with inferior cleaning solution.Sprinkler head is very easy to be contaminated and wear, so please use manufacturer specified products and quality inspection products to clean the nozzle.
6.high pressure cleaning nozzle
When cleaning the sprinkler head, if the sprinkler head is slightly blocked, it is recommended to use a vacuum cleaner to wash out the dust, and then carry out careful cleaning. Do not use this way.
7. Soak the cleaning nozzle
Although the cleaning solution can be more effective to soak the nozzle in the cleaning solution for a long time, the cleaning solution is corrosive to a certain degree and will affect the nozzle orifice itself if the time is more than 48 hours.Therefore, generally only take appropriate amount of the nozzle into the cleaning can be.
8.acoustic wave cleaning nozzle
Clean the nozzle with ultrasonic cleaner for a long time.In fact, if you usually pay attention to the maintenance of the nozzle, there is no need to carry out ultrasonic cleaning.Ultrasonic waves can cause bad effects on sprinklers.However, if the blockage is severe and ultrasonic cleaning is needed, the cleaning time should be up to 3 minutes.If the first cleaning is not clean, please wait for the nozzle to naturally cool down to normal state before the second cleaning.
9. Use bad ink
Fill different batches of ink at will, or use inferior ink, cleaning fluid.Two different configurations of ink mix will change the ink color and quality, the quality of the ink will affect the printing effect and clogging the nozzle, damage the nozzle life.
The above is in the use of UV flatbed printer several dangerous operation, UV flatbed printer correct use and maintenance, not only can ensure the normal production and operation of the machine, but also can prolong the service life of UV printer, can greatly reduce expenses and costs.Some incorrect operation, not only greatly reduce the service life of the printer, but also seriously affect the production efficiency.
